Artificial turf with upstanding qualities

Artificial turf is robust, durable and stands up to any weather. It allows to practise and to play all the year round and therefore became essential for today’s football.

The artificial turf developed by Empa and TISCA TIARA.

A research team of Empa’s Advanced Fibers Laboratory, together with TISCA TIARA, a manufacturer of textile-based floor coverings, has developed a bi-component fibre. It contains two different polymers. The polyamide core has excellent recovery properties and therefore the fibre returns to an upright position again and again. The low-friction sheath of polyethylene avoids injuries after a fall. The turf has already been laid on two football pitches, one in Ecublens near Lausanne and the other in Bürglen in the Canton of Thurgau – and to the complete satisfaction of the footballers. It fulfils the essential requirements and comes visually very close to the natural grass which it is intended to imitate.

Either a flat pitch or abrasions
Artificial turf has been used since the 1960s. However, all the previous generations exhibited defects: The first generation of artificial turf was manufactured using polyamide fibres with excellent recovery properties and which always stood upright. But it’s exactly these resistant fibres which frequently led to grass burns and abrasions whenever someone took a tumble.

That’s why second-generation fibres consisted of polyethylene whose properties were much gentler to the skin. In practical use, however, these fibres also exhibited a serious defect: their resilience, or ability to stand upright after repeatedly being trampled upon, was very poor. Over time, the load on the fibres led to a downright flat pitch. That was not only visually unattractive, the “bent over” blades of artificial grass also changed how well the turf could be played on. As a result, an attempt was made to support the blades with sand or granulated material. Today, turf with a granulated infill is very common. However, it needs a lot of maintenance.

Different requirements for the artificial turf
“The requirements on artificial turf are quite varied,” notes Andreas Tischhauser, head of marketing at TISCA TIARA. “For instance, footballers want an especially soft grass surface while pitch operators want one with a long service lifetime. And, of course, it must also meet ecological requirements.”

The new fiber, to be developed in the framework of project financed by the Swiss Innovation Promotion Agency CTI, had to meet quite a number of demands. It should exhibit high resilience as well as optimal sliding friction behaviour. Two properties implies the need for two components, thought Rudolf Hufenus, fibre expert at Empa in St. Gallen. According to this idea, such a fibre should contain a hard polyamide core surrounded by a low-friction sheath of polyethylene. Various cross-sections of the fibre have been modelled. The initial idea that the fibre should contain only one thick core failed. This fibre did not pass the Lisport test, which checks for long-term mechanical wear. With trial and error the project team finally created an optimal cross-section Instead of one core, the fibre consists of five thin ones. "We’re the first ones who have followed such a project through from the development of the fibre to the laying of the artificial turf“, boasts Hufenus proudly. The fibre’s resiliency qualities are guaranteed for years, as the Lisport test was able to prove.

Cross-section of the fibre: It consists of five thin cores of polyamide and a sheath of polyethylene.

The novel artificial turf meets all of TISCA TIARA’s needs: "We fulfilled the essential requirements of our industry partner for a new fibre used in artificial turf", adds Hufenus.